Re: Fuel tank
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Fuel tank



--- In BaadAssGremlins@xxxxxxxxxxxxxxx, Plumpy72@xxxx wrote:
> I saved myself $25 today by donig something myself instead of paying someone 
> else. 
> 
> I was suppose to go to the sheetmetal shop today to have them shape my fuel 
> tank. Instead, I used some pieces of angle iron, clamps and plywood to bend the 
> sheetmetal to is shape. I went to the hardware store and got a small box of 
> self tapping screws and used them to attach the sides. 
> 
> Once I had it together, I slid it up under the Gremlin to see if it fit. It 
> took a couple of tries but I finally got it in. I would have hated to spend all 
> that time fabricating a fuel tank and have it not go in............now that's 
> STRESS!!
> 
> Once I knew I could get it in, I concentrated on bending flat bar to secure 
> the tank. I'm still not done, but I've accomplished a lot. 
> 
> Tomorrow is another day..........
> 
> Rick

Good deal on the tank fitting. Are you going to use the original filler neck?
"Doc"





Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated