--- In BaadAssGremlins@xxxxxxxxxxxxxxx, "lumina333" <lumina3@xxxx> wrote: > ER, I was referring to what Doc said? > --- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin- > davis@xxxx> wrote: > > A.,...... ER..... Um ....we were talking about Connecting > rods.......not push rods. You can get push rods new cheap. > > Davis > > > > lumina333 <lumina3@xxxx> wrote: > > I figure I can buy a new set of pushrods cheaper than having the > old > > ones magnafluxed. > > --- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin- > > davis@xxxx> wrote: > > > Unless a rod bearing has gone bad and pounded the bearing to > death > > destroying the rod the rods can magnafluxed and the piston end can > be > > rebushed and it will be as good as new for a mild street engine. > > Befor removeing the rod caps mark with a center punch the rod cap > to > > that rod as they are machined together and need to go back on > exactly > > as they came apart. > > > "Doc" > > > > > > Correct again Doc! But the rods and caps should have their > > corresponding # stamped on the side of each. So no mix up If you > pay > > attention. > > > > > > Davis > > > > > > > > > > --------------------------------- > > Yahoo! Groups Links > > > > To visit your group on the web, go to: > > http://groups.yahoo.com/group/BaadAssGremlins/ > > > > To unsubscribe from this group, send an email to: > > BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx > > > > Your use of Yahoo! Groups is subject to the Yahoo! Terms of > Service. I was refering to connecting rods not push rods. Push rod's are a dime a dozen, connecting rods are a nice piece of change new if you can get them, stock or aftermarket. "Doc"