Re: Ye Ole 360

["amc74hornet" <amc74hornet@xxxx>]

--- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin-davis@xxxx> wrote:
> 
> 
> 
> Unless a rod bearing has gone bad and pounded the bearing to death destroying the rod the rods can magnafluxed and the piston end can be rebushed and it will be as good as new for a mild street engine. Befor removeing the rod caps mark with a center punch the rod cap to that rod as they are machined together and need to go back on exactly as they came apart.
> "Doc" 
> 
> Correct again Doc! But the rods and caps should have their corresponding # stamped on the side of each. So no mix up If you pay attention.
> 
> Davis 
> 
> Yahoo! Groups SponsorADVERTISEMENT
> Click Here
> 
> ---------------------------------
> Yahoo! Groups Links
> 
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/BaadAssGremlins/
> 
> To unsubscribe from this group, send an email to:
> BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx
> 
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Old age and experience has made me mark everything I disassemble. Old habbits die hard especially when you have been doing them for almost 40 years. I'm to old to change my habbits now, that's why I still drive 74 AMC Hornet Hatchbacks!!! LOL 
"Doc"