ER, I was referring to what Doc said? --- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin- davis@xxxx> wrote: > A.,...... ER..... Um ....we were talking about Connecting rods.......not push rods. You can get push rods new cheap. > Davis > > lumina333 <lumina3@xxxx> wrote: > I figure I can buy a new set of pushrods cheaper than having the old > ones magnafluxed. > --- In BaadAssGremlins@xxxxxxxxxxxxxxx, Davis Martin <martin- > davis@xxxx> wrote: > > Unless a rod bearing has gone bad and pounded the bearing to death > destroying the rod the rods can magnafluxed and the piston end can be > rebushed and it will be as good as new for a mild street engine. > Befor removeing the rod caps mark with a center punch the rod cap to > that rod as they are machined together and need to go back on exactly > as they came apart. > > "Doc" > > > > Correct again Doc! But the rods and caps should have their > corresponding # stamped on the side of each. So no mix up If you pay > attention. > > > > Davis > > > > > --------------------------------- > Yahoo! Groups Links > > To visit your group on the web, go to: > http://groups.yahoo.com/group/BaadAssGremlins/ > > To unsubscribe from this group, send an email to: > BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx > > Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.