Anyone got a Fraud 9" pig laying around? I'm looking for a 3:25 or 3:50 geared center section for one. I found some cut to fit 31 spline axles that are made by Yukon. They are pretty cool as they are splined for 5-6 inches [forget the exact length]. You just cut them to length. With my 56" housing they will work well as one side will only be a 1/4 longer then the minimum length of 25.5" So it's almost an exact fit when cut! The other side will be 3"s longer. They are priced good as I can get a pair off Ebay for $180 shipped, yukon has good name, we have very good chop saw here at work too. I asked the seller how they cut them and he said a chop saw does fine if you take your time. I think there is a place down town with a cold saw. I may ask them what they charge for a cut. Anyway, the problem...always is one... My housing is late model big bearing.... axles are intended for small bearing housings...arg.... I found the proper bearings. I'm still trying to match up a seal for small bearing axles in a large bearing housing. Anyone know a Ford 9" guru? Help! I know it's Off topic, but it is going in the American! I got the housing yesterday. It's a nice piece. $235 cut to end up at 56" with late model ends for Exploder discs and fill and drain plug bungs in place. He painted it too, but that's coming off so I can do it myself and make it all spiffy and put the spring perches on. -- Mark Price Morgantown, WV 1969 AMC Rambler, 4.0L, EFI, T-5 " I was different before people dared to be different" _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://www.amc-list.com/mailman/listinfo/amc-list