Ok, you've used baling wire not. Where are the chewing bum and duct tape? LOL Joe Fulton --- On Fri, 6/18/10, tom jennings <tomj@xxxxxxx> wrote: From: tom jennings <tomj@xxxxxxx> Subject: [AMC-list] 195.6 OHV, lessening valve cover leaks... To: "AMC/Rambler owners, drivers and fans." <amc-list@xxxxxxxxxxxx> Date: Friday, June 18, 2010, 5:53 PM I worked out a completely trivial trick to stop almost all oil from dripping onto the rear end of the valve cover seal. I've been too cheap to buy a new valve cover seal, and with the higher volume from my hacked oil pump, with the valve cover off oil drips off the end of the rocker shaft right onto the lip at the back of the head. With a bent 5" piece of baling wire the engine runs dry with the valve cover off. Pics and a movie: http://wps.com/AMC/195.6OHV/Valve%20cover/ -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://list.amc-list.com/pipermail/amc-list-amc-list.com/attachments/20100618/0fd96bfb/attachment.htm> _______________________________________________ AMC-list mailing list AMC-list@xxxxxxxxxxxx http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://list.amc-list.com/pipermail/amc-list-amc-list.com/attachments/20100618/d84e4429/attachment.htm> _______________________________________________ AMC-list mailing list AMC-list@xxxxxxxxxxxx http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com