Re: [Amc-list] 195.6 OHV Progress Sorta

[JOE FULTON <piper_pa20@xxxxxxxxxxx>]

Well, I want to keep the cost down somewhat and I just
assumed that getting another block tanked and bored
would be the cheapest alternative.  I'll save this
block for awhile.  If anyone needs a block and can
find oversize pistons bigger than .060 over, they can
have the block.

Regards,
Joe
--- Tom Jennings <tomj@xxxxxxx> wrote:

> On Sat, 16 Feb 2008, JOE FULTON wrote:
> 
> > It's not a perfect world or at least a cheap one.
> 
> 
> > with a new .060 oversize piston in #1 cylinder the
> > piston skirt to bore clearance was excessive.  The
> > manual says .0006 to .0017 is acceptable.  I was
> > measuring at least .004  Two other cylinders were
> 
> So what does sleeving cost? Are stock-bore pistons
> easier to
> find and is there any cost offset because of that?
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
>
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list
> 

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list