On Sat, 2007-06-30 at 09:01 -0400, Matt Haas wrote: > Brazing will be plenty strong enough for this repair if you want more > strength than JB Weld and screws. BTW, if you go with screws, you > probably want to use button head screws so you don't have sharp corners > digging into the floor pan. Good point on the screw heads; I'll watch for that. I may buzz the top with a disc to smooth the screw heads as I already have a box of 100 SM screws. I don't have a brazing setup, just little MIG, and I'm an (as yet unpracticed) lousy welder, though I may do some practice runs and MIG might work out, esp. since I'm doing an epoxy liner, pinholes won't matter. _______________________________________________ Amc-list mailing list Amc-list@xxxxxxxxxxxx http://www.amc-list.com/mailman/listinfo/amc-list