I have the D60-2 in the rear, and a closed-knuckle D44HD from a '67 J-3000. The passenger side u-joint went, and took the axle ends with it. I'm looking to replace the '67 D44 shafts with stronger units. Used D60 front ends are almost as expensive as a NEW D60 front here, so a swap is too pricy for me. I have heard of Moser, Strange Engineering, and Warn. I'm looking for the stronger aftermarket chrome-moly ones, about SAE 4340, preferably with the 760X u-joint. Do you know of, or had dealings with , a good, reputable company that sells these? I need a new set ASAP, so I can get the old girl back on the road (and the trail). ----- Original Message ----- From: "Jim Blair" <carnuck@xxxxxxxxxxx> To: "amc" <mail@xxxxxxxxxxxx> Sent: Saturday, January 01, 2005 8:35 AM Subject: axle shafts (was Re: Islam-a-Bad) > A: I will skip the religious stuff except to note I have family in Indonesia > and other countries doing what the bible tells them to. (several have lost > their lives in that effort) As for the axles, do you have a D60-2 or Dana 44 > rear axle? Moser are good, but I upgraded my J4000's rear axle to a J20 full > float. I could have used the parts front axle I had to make it 5 lug, but > the closed knuckle dana 44 front axle is begging to be swapped as well (I > have that from a J20 as well, but it requires some mods to bolt in, unlike > the rear axle) I also did a rear shackle flip to gain 8" of rear lift to > clear 33/12.50/16.5 tires on wagon wheels, even fully loaded (2 tons of > brick and a bunch of other stuff.) > > > From: "Steven M.Dristy, Jr." <soundwve@xxxxxxx> > Subject: Re: Islam-a-Bad > To: mail@xxxxxxxxxxxx > Message-id: <002801c4eefc$c9fbace0$2802a8c0@xxxxxxxxxxxxxxxx> > > And people wonder why I live in Alaska. Here you learn tolerance, or you > don't walk the streets alone at night. (Utter an anti-Alaska Native slur in > Fairbanks, and you'd better run!!) > > (snip) > Please take your religion-based hatred somewhere else. It is not welcome > nor wanted here, and I do not wish to read it. > > AMC content: broke an axle shaft in my '73 J-4000, and need to order a new > one. Want to buy > > a set of Moser axle shafts. Anyone had experience with this manufacturer?? > > >