Jim, I am just about ready to put my 401 back together also and it sounds like you are going with the same parts as I did on the block/pistons. My cam set up, I went with the comp cams magnum 292 kit with roller rockers. SS valves also. Edelbrock torker W/Edelbrock 780 carb.I have not done any research on the distributor yet, need to do that. Bob in MN --- In BaadAssGremlins@xxxxxxxxxxxxxxx, Jim Shadwick <idahoamx@...> wrote: > > Well finally got the 360 out of the Gremlin....it is now awaiting its > new bullet.....waiting to get the crank back from > the balance shop and the pistons and rods assembled....should get both > tomorrow.....has taken a lot more time > than I thought it would.... anyway....I am getting close to putting the > new engine together...... > > All the 360 exterior parts are going on the 401.....so I will be tearing > it down in the morning....going to do a valve job > on the heads.....They have been ported some already....with SS > 2.08I/1.68 E valves....and milled around .035..... > The 401 short block will of course have the factory forged > crank/polished rods and 30 over Speed-Pro 2380 > forged pistons...CR will be around 9.8 to 1.....I kept the CR on the low > side because this may become a street cruiser > motor in the AMX in the future...... > > My plan is to have it up and running by the middle of next > week.......ready for Test & tune on the 21st and > the first Club race on the 27th..... > > Jim > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/BaadAssGremlins/join (Yahoo! ID required) <*> To change settings via email: mailto:BaadAssGremlins-digest@xxxxxxxxxxxxxxx mailto:BaadAssGremlins-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/