Re: [BaadAssGremlins] More floorboard questions
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [BaadAssGremlins] More floorboard questions



Title: Re: [BaadAssGremlins] More floorboard questions
I used a heat gun and a putty knife/scrapers to get most of it off. Scraped off pretty easy when it got warm. Cleaned off the rest with mineral spirits/paint thinner. Stripper should work too, but a lot less mess if you scrape most of it off first.
Onree


on 7/20/06 1:11 PM, baadass73gremlin@xxxxxxx at baadass73gremlin@xxxxxxx did write:

Ok Like i said earlier i have a few pin holes in my floors of my 73 Gremlin.i also want to get all the tar crap coating off of the trans tunnel and basically sand my entire floorboard bare ,treat the rust and hit the whole floor with POR15.would aircraft stripper work on the tar stuff?
Bart
__._,_.___


SPONSORED LINKS
Spirit Automotive maintenance Automotive radiators
Carnival spirit Spirit phone system Spirit medium


YAHOO! GROUPS LINKS




__,_._,___

Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated