I finally got to see how good the auxiliary cooling fan worked yesterday while waiting for almost 25 minutes in line at the drive in bank window with the car running and the A/C on. Since I still don't have the thermostat it is wired to a terminal that becomes hot when the ignition is turned on. The car ran amazingly cool only slightly warmer than normal and let me tell you it was very hot and humid. The sun was going in and out all day so at 11:30 am I decided to see about installing the tinted AMC letters on the windshield while parked in the street in front of the house. I was only going to do a couple but 4 1/2 hours later they were all on. It took a fair amount of time to get the spacing of the letters right. Also my arms hurt so bad from the installation and my arthritis that I had to take some pain killers and rub Aspercream on both my arms. But it was worth it as I got the desired effect. The top 4 inches of the windshield is factory tinted and the letters are in the factory tint and just show up very slightly. I achieved the subtle look I wanted. Due to the spacing of the words American Motors across the windshield there is a 5" gap between the American and Motors. Today to make this look more even I will make a rectangular R/W/B style AMC emblem out of tint and install it there. But not today as it is !@^& raining again!!!!! After I finished the lettering job I stopped by to see the guy about removing the bumper and putting the last 2 screws in the fan and oil cooler. I explained how I wanted it done and he told me he had a better idea at which I told him it would not work and no matter what the bumper had to be removed. The bumper has been off to replace the rubber filler a few months back and the bolts were not rusted tight and when replaced they had anti-seize applied to the studs, so bumper removal is just a matter of removing 8 bolts. After looking under the car he realized I was right. I have only been working on my other 74 Hornet for 33 years since it was new. Since I am paying for the work I expect it to be done my way. So he said it was my way or the highway? at which I replied no my way period!!!! He wanted to know when I wanted it done. I told him I would get back to him on when I wanted it done. I think I will just wait till my friends shop slows down and let him do it all when I get the thermostat for the fan, wire up the on off on switch, deep tranny oil pan, billet aluminum over flow tank and a grease job and oil change. I was just anxious to get the grill back in but I will just have to wait. If the rain stops I will re-stripe the black double factory pin stripe some time this week that is worn off in spots from some idiot in the past with a buffer. "Doc" ------------------------ Yahoo! Groups Sponsor --------------------~--> Yahoo! Groups gets a make over. See the new email design. http://us.click.yahoo.com/XISQkA/lOaOAA/yQLSAA/YtqqlB/TM --------------------------------------------------------------------~-> Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/