Re: [BaadAssGremlins] Thanks and Another Question Too; Engine set up.

[Baad73Grem@xxxx]

In a message dated 7/26/03 12:03:29 AM Eastern Daylight Time, formula421@xxxx writes:

> The 304 in the car was supposidly rebuilt and never fired (which I 
> dont believe)I pulled a valve cover and Its Spotless....I mean eat 
> off the valvetrain spotless...now the problem..The car sat so long 
> the engine is setup. I pulled all the plugs and used PB blaster in 
> all the cylinders and then added marvel mystery oil. I tried to turn 
> it over with the starter, no dice. Tried with a breakerbar...nope; 
> afraid I'll snap the balencer bolt off....Whats the best/easiest way 
> to free this bad boy up?? Im pen to all suggestions. thanks!!


Hmmm you try and turn it over with the spark plugs out of it?if i were you i'd pull the engine and make damn sure its been done right,i never trusted what the former owner says if i buy a non running car i'm not trying to scare you maybe someone on here can add some suggestions??anyone wanna try this one?
Bart M.
73 Gremlin 360/T10
Moderator"BaadAssGremlins"