Re: [Amc-list] windshield squirter location on an American

[Tom Jennings <tomj@xxxxxxx>]

-- Frank Swygert <farna@xxxxxxx> wrote:
> 1. Do you at least have a vacuum storage cannister? If not, get one of
> the balls or better yet quart (or half gallon) "juice can" types.

I didn't think it would make enough difference... but I guess I should try 
it.

> 2. I mean the brace that the hinges mount on -- the only one under there,
> unless you count the two "truss rods" going out to the edges of the hood.
> Be careful closing the thing and make sure the hinges are oiled good!

Duh, how did I ignore that brace? Yes, there's an oval in the middle; so 
your AMerican squirter was in there?

I see your point about hinge oiling; I think I did, no problems with it, 
but I'll check! It would suck to buckle the hood!


> The newer gasket material probably allows the 15K interval,

I'll probably do it annually. It doesn't even take an hour. The biggest 
PITA is you gotta remove the carb on the two bbl. Looks like the 1bbl you 
don't have to.

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list