Re: Putting 360 in 69 Rogue
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Putting 360 in 69 Rogue



On December 3, 2004 Tom Jennings wrote:

> > Well it's been 4 years, but I'm finally putting a '72 360 in my 69 Rogue.  Problem is, when I lower it into the engine bay, the motor mount studs are about 1/2" too far forward to drop into the slots/holes on the crossmember.  The engine is right up against the firewall, so there's no room to slide it back.
> >
> Is the stud offset 1/4" front to rear? Swapping the left with
> the right might shift the position of the studs.
> 
Thanks for the suggestion, Tom.  Unfortunately, both are about 1/2" too far forward and the studs seem to be centered front to back on the rubber pad.  Worst is, I'm reusing the motor mounts from the 290 that came out of the Rogue, so the right and left mounts are just like they were with the old engine.  The 360 had the big car mounts, and they are way too wide to fit the Rogue crossmember, so I stuck with the '69 mounts.




=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist






Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated