ALL FORD FE big blocks 352,360,390..even the 428's had "352" cast on the drivers side front of the block. All were derived from the same basic casting. Another way to confuse folks. Only way to tell is internal or a ### above the starter on the block.--- In BaadAssGremlins@xxxxxxxxxxxxxxx, Terry.Atkins@... wrote: > > I agree with you Bart. If it is stamped 352 I would think that is what it is. > It has been a long time since I dealt with Fords but I don't think you could > tell by looking if it was a 352 or a 390. > Terry > > > > > > > In a message dated 4/22/2006 6:31:51 P.M. Eastern Standard Time, > eddiestakes@... writes: > > One fellow said it was definately a AMC 390. Hmm....says 'powered by ford' > on the valvecover. Check out the weird oil filter. It also has a small stamp > on front of block that says 352, not sure what that is however. Hope these > photos don't make anyone lose their tacos....but it IS a AMC. Ok, just a rusty > AMC that has been professionally hand painted by me with Rustoleum, not bad eh. > Eddie Stakes' > Planet Houston AMX > 713.464.8825 > > > > > some tard dropped a Ford FE 352 big block in that AMX.is it just sitting in > there or is it bolted? > Bart > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/