In a message dated 8/26/2004 6:10:58 PM Eastern Daylight Time, "John W Rosa" <JohnRosa@xxxx> writes: >TM, > >Got a photo handy of the grind job you did? > >John > >-----Original Message----- >From: themixtoo@xxxx [mailto:themixtoo@xxxx] > >John, The passenger side exh manifold is the tight fit. I had to trim a >little off the rh strut rod brace and the exhaust manifold where the three >bolt flange is and once installed, it was so close to the 'frame', that I >even ground off the casting bumps on the side of the manifold. I must have >trail fit this thing ten times before I said enough was enough. > > >John, No I don't, but the wife just bought a new digital camera and when I get back from our vacation (Sept 10) I'll try to get a shot of it for you. 'The Mix' >