From: AMC74HORNET@xxxx Date: 2004/08/27 Fri AM 04:54:18 EDT To: BaadAssGremlins@xxxxxxxxxxxxxxx Subject: RE: [BaadAssGremlins] Hornet V8 bolt-on upgrades Qs Or just wait for the new Edelbrock'shorty'headers to come out. BartI saw a 74 Hornet at the Ardsley Show 2 years ago with these Free Flow
--- Begin Message ---TM,
- From: "John W Rosa" <JohnRosa@xxxx>
- Date: Thu, 26 Aug 2004 18:10:58 -0400
Got a photo handy of the grind job you did?
John
-----Original Message-----
From: themixtoo@xxxx [mailto:themixtoo@xxxx]
John, The passenger side exh manifold is the tight fit. I had to trim a
little off the rh strut rod brace and the exhaust manifold where the three
bolt flange is and once installed, it was so close to the 'frame', that I
even ground off the casting bumps on the side of the manifold. I must have
trail fit this thing ten times before I said enough was enough.
--- End Message ---