I'm finally working on the Gremlin again (its been way too long). I had to get other obligations out of the way first. Anyway, my friend Garry and I timed it and while doing so, I had a fuel leak. I turned off the car after a few nice revs (hard to resist doing this with open hedders, heh), and I heard a pffft pffft noise coming from under the car. I almost crapped cuz I had fuel spraying right onto the hedder where the exhaust was coming out! Thankfully it was timed well enough that I had no fire or I might not be writing this today. Anyway, I ordered my exhaust today (be here tomorrow). Flowmaster series 40s with Delta flow. As Bart is a big fan of these, I must admit I did it only for the sound they make, 2.5" duals will flow nicely for a 300hp engine. I'm only using this for street so its all good. Can't wait to get them installed with an 'H' or 'X' pipe. I also took my rad in to be cleaned and patched (nasty scaly inside). I didn't want the car overheating on her maiden voyage (I don't think I'd like being embarrassed like that). I also had to buy new gaskets for my carb cuz it was pissing gas all over the intake (after I got the previous leak fixed). Lastly, I took in my rear window latch and "gremlin man" locking gas cap to be re-keyed to the same as my doors. Next thing after exhaust is new front tires. I'm almost scared to drive it... I can tell by revving it up in the garage that the old 360 has got a lot of guts. Its going to be fuuuuun! I'll try to keep y'all updated.