Ohhhh!!! That is sad. I so much wanted to do business with Mac. I hope a good Rambler guy takes it and does well with it. On Tue, Feb 15, 2011 at 1:39 PM, Joe Fulton <piper_pa20@xxxxxxxxxxx> wrote: > I think Mac McCoy is selling his business due to illness. Sad to hear but I > think it's true. > > Joe Fulton > > > > ----- Original Message ---- > From: Bruce Griffis <bruce.griffis@xxxxxxxxx> > To: "AMC, Rambler, Nash, Jeep and family" <amc-list@xxxxxxxxxxxxxxxxx> > Sent: Tue, February 15, 2011 10:14:55 AM > Subject: Re: [AMC-list] When replacing door and trunk gaskets, ... > > Thanks. These are new, came from Galvins, and seem to fit well. There > are a few places where they are a little loose (near where the door > handle is). I wasn't sure if we should remove them and use some > adhesive, or just use a little where it is loose. > > Don't know if you found a rear window gasket. Kevin e-mailed Mac McCoy > and hopefully we'll be in business. Peter Stathes for the front > gasket, Galvin's for the doors and trunk, Mac for the rear gasket > (hopefully). Lol - we're trying to visit each shop. I know I got stuff > from Kennedy's a while back - but we've never checked out Blaser's > yet. > > By the time the Rambler's done, hopefully we'll have supported each > vendor in some small way. > > On Tue, Feb 15, 2011 at 12:55 PM, Joe Fulton <piper_pa20@xxxxxxxxxxx> wrote: >> If you have a new gasket (door gasket specifically) with the new fastners, you >> shouldn't need to use much if any glue. I just did that same job on the front >> doors of my Rambler (just like yours) and I don't recall using any > weatherstrip >> adhesive. I think my gasket came from Metro Molded parts. >> >> >> Joe Fulton >> >> >> >> ----- Original Message ---- >> From: Bruce Griffis <bruce.griffis@xxxxxxxxx> >> To: "AMC, Rambler, Nash, Jeep and family" <amc-list@xxxxxxxxxxxxxxxxx> >> Sent: Tue, February 15, 2011 9:36:13 AM >> Subject: [AMC-list] When replacing door and trunk gaskets, ... >> >> When you replace the door and trunk gaskets, do you just use the press >> fit, or do you glue them as well? There are a few spots on the door >> where the seals need a touch of glue - just wondering if I should >> remove and glue the whole thing. >> _______________________________________________ >> AMC-list mailing list >> AMC-list@xxxxxxxxxxxxxxxxx >> http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com >> >> _______________________________________________ >> AMC-list mailing list >> AMC-list@xxxxxxxxxxxxxxxxx >> http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com >> > _______________________________________________ > AMC-list mailing list > AMC-list@xxxxxxxxxxxxxxxxx > http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com > > _______________________________________________ > AMC-list mailing list > AMC-list@xxxxxxxxxxxxxxxxx > http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com > _______________________________________________ AMC-list mailing list AMC-list@xxxxxxxxxxxxxxxxx http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com