Re: [AMC-list] Gremlin with Overdrive Question

[Ken Ames <ameskg@xxxxxxxxx>]

It as 95$ worth at 117.4c/L (444.4 / US Gal).

Ken


Quoting Bruce Griffis <bruce.griffis@xxxxxxxxx>:

> $100 bucks!!!!! That makes the Metropolitans look a LOT more
> attractive! Or well-tuned Americans, perhaps with overdrive!
> 
> I'm heading to a club meeting this weekend and will start asking
> actual questions about tuning and maintenance. Any local club members
> be forewarned! If you see a middle-aged overweight guy heading your
> way, I'll be asking questions! (hahh!!! middle-aged, overweight guy.
> If you were to avoid talking to middle-aged overweight guys at carclub
> meetings, you'd only have a few folks talking)
> 
> On Fri, Feb 11, 2011 at 9:50 AM, Ken Ames <ameskg@xxxxxxxxx> wrote:
> > 47$? That's nuthin'. I've put almost 100$ into the Eagle. :-0
> >
> > Ken
> >
> >
> > Quoting Bruce Griffis <bruce.griffis@xxxxxxxxx>:
> >
> >> I haven't seen that. But that sounds like a good setup, and should
> >> give you some really nice mpg's!
> >> After paying $47.58 yesterday to fill up my wife's Highlander, I'm
> >> gulping at gas prices again.
> >>
> >> On Thu, Feb 10, 2011 at 11:02 PM, Joe Fulton <piper_pa20@xxxxxxxxxxx>
> wrote:
> >> > I asked this same question on the AMC forum so pardon the repeat if you
> >> monitor
> >> > both sites.�  I'd appreciate any information folks can offer though.
> >> >
> >> > I�  am a few weeks away from installing this but I thought I would ask
> the
> >> > question.� �  I have an NOS 150T three speed tranny with OD.� � 
> My Gremlin
> >> (76) had
> >> > a T-14 in it.�  I both� trannies but� I have not measured or
> compared the
> >> locations
> >> > for the� tranny crossbrace and mount� and I'm wondering if the OD
> actually
> >> takes a
> >> > special mount.�  I'll check Rockauto listings tonight, but thought I'd
> ask
> >> the
> >> > question.
> >> >
> >> >
> >> > Another issue.�  I have an NOS overdrive switch with turn signal
> stalk.� �
> >> What I
> >> > don't have is the wiring harness for the overdrive.� �  I can
> fabricate a
> >> harness
> >> > from the wiring diagram in the TSM but I'm concerned about the cutout
> >> switch on
> >> > the throttle linkage.�  What did AMC use there?� �  What is a good
> generic
> >> switch
> >> > to use?
> >> >
> >> > Has anyone done this or does anyone have an 70s AMC with overdrive they
> can
> >> > photograph?
> >> >
> >> > Joe Fulton
> >> >
> >> > _______________________________________________
> >> > AMC-list mailing list
> >> > AMC-list@xxxxxxxxxxxxxxxxx
> >> > http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com
> >> >
> >> _______________________________________________
> >> AMC-list mailing list
> >> AMC-list@xxxxxxxxxxxxxxxxx
> >> http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com
> >>
> >
> >
> > _______________________________________________
> > AMC-list mailing list
> > AMC-list@xxxxxxxxxxxxxxxxx
> > http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com
> >
> _______________________________________________
> AMC-list mailing list
> AMC-list@xxxxxxxxxxxxxxxxx
> http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com
> 


_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com