Re: [AMC-list] 195.6ohv, ARP studs and head torque

[Joe Fulton <piper_pa20@xxxxxxxxxxx>]

Tom,

Just curious, what are you using for a Tach of is your rprm calculated for wheel 
size, etc.  I may but a three-gauge panel below my dash (temp gauge doesn't work 
and I'd like to know voltage too).    I could add a tach I guess.

Joe Fulton



----- Original Message ----
From: tom jennings <tomj@xxxxxxx>
To: "AMC/Rambler owners, drivers and fans." <amc-list@xxxxxxxxxxxx>
Sent: Sun, December 5, 2010 4:07:05 PM
Subject: [AMC-list] 195.6ohv, ARP studs and head torque

I can tell you with a summer of LA freeway driving, that RV cam that Doug
Galvin sells is a winner. That plus the Weber 32/36 DGEV carb and a 2.25"
exhaust and Pertronix ignition and I drive all day in freeway traffic, 65 -
75 mph and it's not even working that hard, 2300 - 2500 rpm (2500=73mph). It
keeps up just fine, and 0 - 60 is a hell of a lot better (though I haven't
measured it, I will soon). The upgraded (Gremlin drum 9x2.5 drilled and
ventilated) brakes are more than adequate. The Twin Stick OD and axle make
the difference.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://list.amc-list.com/pipermail/amc-list-amc-list.com/attachments/20101205/8fa65b03/attachment.htm>

_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com

_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com