Re: [AMC-list] Tranny question

[Jim Blair <carnuck@xxxxxxxxxxx>]

The linkage should unbolt from the valvebody shaft to swap between them. I've done it to 998/727 swaps in the past with no prob.


From: russ hathaway <russh97309@xxxxxxxxx>
To: Rambler Nash Jeep and familyAMC <amc-list@xxxxxxxxxxxx>
Subject: [AMC-list] Tranny question
Message-ID: <855940.67400.qm@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
Content-Type: text/plain; charset=us-ascii
 
I have a transmission from a 75 something, it is a TF 904. The numbers on the engine shows it to be a 75 258 so I am assuming it to be a column shift application.
I have a floor shift from an eagle. The shft rod goes into a grommet that takes a 1/2 inch hole, but the tranny arm is way too narrow.
Did they use a different arm coming off the transmission for the floor shift cars? I can drill out the arm but that leaves very little meat on the tranny arm left over.....Russ 		 	   		  
_________________________________________________________________
Hotmail has tools for the New Busy. Search, chat and e-mail from your inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID27925::T:WLMTAGL:ON:WL:en-US:WM_HMP:032010_1
_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com