Re: [AMC-list] What gauge sheetmetal for the trunk and doors?

[adh@xxxxxxxxxxxxxxxxx (Sandwich Maker)]

" From: Bruce Griffis <bruce.griffis@xxxxxxxxx>
" 
" I have a small flat section of my trunk near the drivers side that
" needs repaired. I took care of a few pinholes, but since the section
" needing replacement is flat - a friend recommended cutting it out and
" hitting it with a MIG welder (after I drop the gas tank).

don't forget to use a phosphoric acid pickle like prep 'n strip before
and after welding!  this dissolves rust and leaves a thin iron
phosphate layer, a barrier to water but not welding, which is in fact
improved.  then paint with rustoleum etc.
________________________________________________________________________
Andrew Hay                                  the genius nature
internet rambler                            is to see what all have seen
adh@xxxxxxxxxxxxxxxxx                       and think what none thought
_______________________________________________
AMC-list mailing list
AMC-list@xxxxxxxxxxxx
http://list.amc-list.com/listinfo.cgi/amc-list-amc-list.com