Re: [Amc-list] seats (Redux)

["piper_pa20" <piper_pa20@xxxxxxxxxxx>]

I looked at a set of 69 Javelin seats today and a set of 70 Javelin seats I 
have.  The methods of fastening to the floor appear to be identical.  Cap 
screws in front bolt holes and studs on the rear flanges.

That may have changed later.  I do seem to remember that my 73 Javelin had 
studs at all floorboard holes but I could be wrong.

Joe Fulton

----- Original Message ----- 
From: "JOE FULTON" <piper_pa20@xxxxxxxxxxx>
To: "AMC/Rambler owners, drivers and fans." <amc-list@xxxxxxxxxxxx>
Sent: Wednesday, February 13, 2008 9:25 PM
Subject: Re: [Amc-list] seats


> I'm almost positive the seat frame dimensions and hole
> locations will match perfectly.  One set of seats
> (1970 I think) should have studs that go through the
> floor and the older seats may have cap screws with
> welded nuts on the bottom of the floor boards.  That
> may interfere with the stud arrangement but you can
> deal with that if it occurs.  I'm just not sure when
> AMC changed over to the stud arrangement on the seat
> frames.
>
> Joe Fulton
> --- Keith Evenson <epd@xxxxxxxxxxxx> wrote:
>
>> Can anyone tell me if high back bucket seats from a
>> 70 AMX will mount
>> in a 68 AMX that now has the original low bucket
>> seats in it?
>> I would imagine they will but I would like to know
>> they will before I
>> buy the new ones and then find out they don't.
>> Thanks Keith
>>
>> _______________________________________________
>> Amc-list mailing list
>> Amc-list@xxxxxxxxxxxx
>>
> http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list
>>
>
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list 

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list