Re: [Amc-list] Re; Pushrod Installation on 232 engine.

[JOE FULTON <piper_pa20@xxxxxxxxxxx>]

Ok then, the rocker shaft assembly is shown on Page 3
of the engine section (1966 TSM).  The rubber band
trick is explained there.  Sorry about the number of
hold down bolts for the shaft.  As I said I was
working from memory.

I don't know if you can insert an errant pushrod
without removing the rocker shaft.  The older TSMs
assume that a person working on an engine has some
experience with the procedures, so specific details
are often left out.

So I am suggesting that you remove the rocker shaft
(six bolts to remove) then get the pushrods in
position and reinstall the rocker shaft.  There may be
another way, but this way will work.  Be sure the
lubrication holes are on the bottom of the shaft when
you reinstall it.

Regards,
Joe Fulton
Salinas, CA

--- Jay <jciampi@xxxxxxxx> wrote:

> Joe,  I have a copy of the 66 TSM. I don't recall
> any info on installing 
> pushrods in the engine section. There are 6 bolts
> that hold the rocker shaft 
> down to the head.
> 
> Jay 
> 
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://www.amc-list.com/mailman/listinfo/amc-list
> 

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list