Re: [Amc-list] Bellhousing shim plate for 1967 232

[Wrambler242@xxxxxxxxxxx]

oh, nevermind, I missed the 67 ! duh, I read it earlier, but forgot it this time.

--
Mark Price
Morgantown, WV
1969 AMC Rambler, 4.0L, EFI, T-5

 -------------- Original message ----------------------
From: Wrambler242@xxxxxxxxxxx
> Not sure when they changed over, but my 82 setup came with the new improved 
> liteweight plate!!!...............
> 
> --
> Mark Price
> Morgantown, WV
> 1969 AMC Rambler, 4.0L, EFI, T-5
> 
>  -------------- Original message ----------------------
> From: Tom Jennings <tomj@xxxxxxx>
> > On Thu, 1 Mar 2007, Jim Blair wrote:
> > 
> > > Come on guys someone out has to have a shim plate out of 6
> > > cylinder
> > > Jeep that you could measure the thickness for me. Help a guy out
> > > &
> > > throw a mic on it & let me know. I would like to get this J
> > > truck on
> > > the road/off the road this summer.
> > 
> > 
> > Not a "jeep" part but an AMC six block-to-bellhousing plate
> > from a pre-72:
> > 
> > steel part    0.090 - 0.95"
> > aluminum part 0.090 - 0.092"
> > 
> > Starrett dial caliper. I measured in a couple of places and made
> > sure there was no mushroomed edge, etc. The range indicates
> > my measurement error (dirt, whatever). As we used to say,
> > 'good enough for government work'. I assume that would be 0.90"
> > if I steel-wooled it spotless.
> > 
> > Yes, one of them is aluminum, which I think is odd too. It
> > doesn't look homemade, it is absolutely identical to the steel
> > part in all ways (apparantly including thickness.).
> > _______________________________________________
> > Amc-list mailing list
> > Amc-list@xxxxxxxxxxxx
> > http://www.amc-list.com/mailman/listinfo/amc-list
> 
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
> http://www.amc-list.com/mailman/listinfo/amc-list

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list