Re: [AMC-List] FWD: wanted: man flywheel for 1967 J3000 232 six (E-stick clutch)

["Swygert, Francis G MSgt 436 CES/CECM" <Francis.Swygert3@xxxxxxxxxxxx>]

I'd have to check the books to see what the E-stick clutch diameter was.
Could be the 10.5" disc (~11.5" circle) with larger bolts. All I recall
for sure is the E-stick used a larger disc and there was a larger bolt
pattern for the "pressure plate" housing. E-stick was available from
61-63, IIRC. 

-----------------
" From: "Swygert, Francis G MSgt 436 CES/CECM"
<Francis.Swygert3@xxxxxxxxxxxx>
"
" The 196 used a small clutch... might be smaller than 9-1/8" though I
" doubt it. The larger pattern in the 196 flywheel I had was around 10"
to
" 10.5".

hmmm...  that's a new one on me.

by '65, all 196s were using 9 1/8" clutches.  that would be your
larger pattern; the bolts are 5/16" and iirc just clear a 10" disk, as
mopar used for the hd slant six.

the 10.5" pattern uses 3/8" bolts in about an 11.5" circle.  all the
'64-'71 199/232/258 flywheels i've seen [not many] have these two
patterns.

_______________________________________________
AMC-List mailing list
AMC-List@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list

or go to http://www.amc-list.com