Re: How much should it cost?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: How much should it cost?



" From: <mail@xxxxxxxxxxxx>
" 
" Boring will run $15 or so a hole. Cleaning (usually done in an oven, no
" liquid involved) around $25. If you're going to store it a while wipe
" the bores with grease (not oil), and other machined surfaces as well.
" Doesn't need to be caked on, just rub it down good -- like greasing a
" cake pan. 

any good machine shop should have an aerosol oil used for preserving
freshly cut surfaces.  it looks thin, and you don't need much, but it
sticks and keeps air out.  my engine friend uses it, and if the
block will be stored for any time he duct-tapes a trash bag around it.
________________________________________________________________________
Andrew Hay                                  the genius nature
internet rambler                            is to see what all have seen
adh@xxxxxxxxxxxxxxxxx                       and think what none thought







Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated