Re: Eagle engine swap?

[adh@xxxxxxxxxxxxxxxxx (Sandwich Maker)]

" From: farna@xxxxxxx
" 
" The EFI is the way to go. The 4.0L will bolt
" right to your 998 and the computer will have no problem with the trans.
" You will either have to modify your bell housing for the CPS (crankshaft
" position sensor) and the AW4 flexplate (required for the stock CPS) for
" the TF torque converter

a wrangler flexplate should be right from the get-go, as they used tf
autos all through the '90s.

another thought: if you get a wrangler 4.0/tranny pkg, compare the
tranny output with yours.  there shouldn't be any difference but
relevant parts will swap if there is.

" With
" the Eagle you need the 87-90 intake (Renix computer, has an EGR valve,
" but can be modified to use later electronics) or a 99+ intake from a
" Grand Cherokee. Otherwise you will have a clearance issue with the power
" brake booster. 

another point - the exhaust.  the '87-'90 'renix' header fits eagles
without clearance issues, but the '91-8 'ho' one needs some bending.
for the '99-up iron split manifolds, just have your muffler shop fab a
y-pipe to suit.

" I'd run the late 2V intake with a 2V to 4V adapter with a Holley 390 or
" 450 cfm 4V carb. That makes a much nicer setup than the old BBD 2V
" carb! A lot of Jeepers do just that, works great for low to mid speed
" torque, not as good as a real 4V intake for higher speeds. You could
" also get the BBD off a late model 318 from a rear drive 80s Dodge
" Diplomat/Chrysler New Yorker. Use the base plate and top off the AMC
" BBD. The 318 BBD has 1/16" larger bores in the center section, the same
" size base and top. Base and top are slightly different between the AMC
" and Chryco versions, that's why the switch. 

later 318s and 225s switched from the bbd to a holley 2280.  it swaps
right into place - on them.  it would take some linkage work - and i
think choke work - to slip onto an amc.

btw i've heard the 318 bbd rated ~350cfm.

" On August 26, 2005 ramblerfreak wrote:
" 
" > i have a 1986 Eagle 
" > []
" > will the 4.0 block bolt up to the 998 tranny? and will i have
" > to modify anything like the int/exh manifolds to use the 2bbl carb
" > set up? or should i try to get the EFI stuff to go along with the 4.0?
" > and if i try to use the EFI will it work with a non computer
" > controlled tranny?
________________________________________________________________________
Andrew Hay                                  the genius nature
internet rambler                            is to see what all have seen

adh@xxxxxxxxxxxxxxxxx                       and think what none thought