It should be a 3/4 ton truck..sounds a little beat up though, accident damage is the worst to fix On August 20, 2005 jamie smith wrote: > I looked at it today (sort of, it has so much stuff around it that I could look real close, not to mention the bees were not happy about me messing with their home). So, since I couldn't look at it very good I don't know if the floors are solid. I don't know if the bed is solid cause he has to clean his junk out of it. (he has 3 motorcycle engines in the cab). it has alot of dings and heavy surface rust on the body. The front has been hit from the right side so the hood doesn't latch (the nose is moved over approximately 3 inches). Not sure if it is frame damage or just body damage. Will check that out when I bring it home in a few weeks. > > I got all the numbers off of it. I finally found my chiltons manual and tried to look up the vin in it but it doesn't match. > > The numbers from the door frame are 3406w and then 200758. And then it says 5,000GVW. My chiltons only shows 3406B,C,D, and E. No W. > > The tag under the hood has 332 and 241. It was so dirt I couldn't tell if it has anything else. > The plates on the side of the truck say J300. > > Jamie Smith > Spokane, WA. > oconner51@xxxxxxxxxxx > > ============================================================= > Posted by wixList Archiver -- http://www.amxfiles.com/wixlist ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist