Re: Part needed, Ballast Resistor? no, radio noise suppressor

[farna@xxxxxxx]

You're dead on Jerry, he's talking about a radio noise suppression condensor (most likely), but you WILL find those ballast resistors in older AMCs (Ramblers) and some newer ones. 1965 and earlier AMC/Rambler V-8s used a ballast resistor, sixes used a coil with built-in resistor. Resistance wires were used from 1967 on. 

Jeep used them at least in the late 80s on 4.0L engines, though not in that location or for the ignition. They use one to cut voltage to the fuel pump when running at low speeds. It's the same 1.8 ohm resistor though. 

On August 17, 2005 Jerry Casper wrote:

> --- R L <super70ty@xxxxxxxxxxx> wrote:
> 
> > Hey all,
> > I am trying to get my 1977 Hornet Sportabout running
> > and while playing with
> > it, we noticed that the ballast resistor(?) had the
> > wire break off of it.
> > This is the cycilnder shaped part the bolts to the
> > ignition coil and
> > connects to the wiring harness. Is that the correct
> > term ballast resistor? I
> > am having a hardtime finding the part locally.
> > Anyone know where I can find
> > one?
> > Thanks
> > Ryan
> 
> 
>  Ryan, AMC didn't use normal ballast resistors,they
> used resistance wire - what you are descibing sounds
> like the radio noise suppressor capacitor put on coils
> to keep the ignition ticking out of the radio. Is it
> silver metal, with a braided wire coming out of it?
> Then it's a condenser, like in your points, NOT a
> ballast resistor - those are white ceramic, usually
> squarish, and get HOT. You'll never find an AMC
> ballast resistor like that <grin!>
> 
> Jerry in Virginia
> 
> 
> 
> ____________________________________________________
> Start your day with Yahoo! - make it your home page
> http://www.yahoo.com/r/hs


=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist