401 rods
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

401 rods



Nick
The rods can be bushed to any size, the issue is that we DON'T have a
drop in rod ( replacement) for the guys that are just needing a rod for a
press fit. Anybody wanting to float them can ( could have), now there is
no choice, you will have to run a floater. I will say that 98% of all
engines I have built have been pressed fit on the pistons and rods. In
the end, the rods will be corrected, and the next batches should be
corrected, and with luck I  ( you can push for it too) can get them to
make the 68-69 390 rod from the same casting. We have looked at it and it
can be done. Yes, always something, BUT we do at least have the 401 rod.

Andre " A.J." Jacobs, 
web page http://southtexasamc.tripod.com
 (830)-980-3165 , akjamc@xxxxxxxx 

Owner & Proprietor, South Texas AMC





Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated