Re: Daily Buzz report

[farna@xxxxxxx]

Armand, how and where is the crossmember mounted? I don;t recall off-hand how the small car tranny crossmember goes in. On the big cars it fits between the rails. It might be easier/better to move the entire crossmember, even if it means a little welding is involved. 


On May 7, 2005 Armand Eshleman wrote:

> I'm still hoping some one can come up with a great idea on how to make a
> flexible transmission mount. The original transmission crossmember is about
> 2 inches below the T5 mount boss and about 4 inches behind it. I bought a
> Mustang transmission mount hoping it would work but so far it doesn't look
> good, unless I fabricate a bracket to weld to the AMC crossmember then I
> could bolt the Mustang mount right up, but that may make the cross member
> hang too low also.
> 
> Take care all,
> 
> Armand
> 
> 
> 
> 
> 
> .


=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist