Re: PS Pressure????
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: PS Pressure????



Hmmm.... I thought there was a valve in the PUMP you could add/subtract washers to change the pressure. I may have to get an in-line valve after all. Borgeson makes a pressure change kit for GM steering as well -- might be for the pump though since I've heard the hot rodders talking about it. 


On April 19, 2005 mail@xxxxxxxxxxxx wrote:

> Uh yeah! When you take the high pressure hose off. You then take that big nut out. Next will be the pressure valve then a spring.
> Replace the valve with one from a vehicle that has less assist or look at the valve. YOu will see a nut on one end with a couple a washer or two under. If you very carefully take that nut off, thats the tricky part, don't damage any of the machined surfaces or crush the valve. One of the companys that specializes in steering makes a tool. I think it is Mullins? Anyway get that nut off. To decrease pressure add washers or to increase presure take them away.
>  You can get washers with the tool. Or take them from another pump valve.
>  Simple and I have done it on my old setup. I dialed the pressure down to almost no assist at all. This does not really increase road feel and some will tell you it is not the "correct" way to do it. Maybe not but it can and does work.
> 
> Mark Price
> mpriceAtwestco.net
> Morgantown, WV
> 69 AMC rambler, 4.0L, EFI, 5 speed
> 65 Ambassador Conv, 327 AUTO, Basketcase
> 01 S-10 CREWCRAP 4X4
> 
> 
> 
> ---------- Original Message ----------------------------------
> From: Tom Jennings <tomj@xxxxxxx>
> Reply-To: mail-From-mprice-westco.net@xxxxxxxxxxxx
> Date:  Tue, 19 Apr 2005 17:56:06 -0700 (PDT)
> 
> >On Tue, 19 Apr 2005 mail@xxxxxxxxxxxx wrote:
> >
> >> Now you know where to look for the valve!
> >> Wrangler, just remove the high pressure line and seat and use a magnet to pull it up out of there and put it in yours. It should do the trick.
> >> I know I looked the spec up in a 95 TSM so it should hold the same at least 91-95 probably clear up till now. Four cylinder may have yet a different valve. I don't think the TSM mentioned egine size though.
> >
> >Wait -- are you saying that setting P.S. pump pressure is as
> >simple as that?!  You just lift it out with a @#$%! magnet? And
> >with that you can tune the amount of assist?!
> >
> >
> >
> >
> >
> >
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> .


=============================================================
Posted by wixList Archiver -- http://www.amxfiles.com/wixlist







Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated