On March 12, 2005 Joe Gray wrote: > Anyone know where to get a intake manifold mounted > heater temp water valve? I need one that threads into > the right rear corner of a V8 intake. It's "cable > controlled"...NOT vacuum. I need it for my 1972 V8 > Gremlin conversion. My Gremlin is a factory 232 with > AC. Heater valve mounts to the firewall. I think i can > use the intake mounted one. I have a RUSTY one on a > 70-72 factory 4bbl intake i've been pondering. My AC > works...why not keep the controls working? Never had a > hot rod with functioning AC! I'm gettin old...i > know!!! Thanks alot,joe > The heater valve that you want is carried IN STOCK by Kennedy American (614)879-7243). Their parts catalog shows the Firewall mounted valve as part number HA162 @ $25, and the valve that screws into the rear corner of the intake manifold as part number HA388 for $35. These are parts manufactured by the original AMC vendor and are NEW, not OLD STOCK. The manufacturer is closing their manufacturing facility here in Ohio, so Jeff Kennedy ordered about a pallet load of the valves. They are exactly correct. I recently replaced an original valve that had just gotten too hard to open & close with a new valve. Wow, what a difference! Part numbers are from the Kennedy American 2004 catalog. Tom Bunsey No, I'm not a shill for Jeff Kennedy, but I Have known him since 1980. And, since he is only ten miles from me, I'm over there quite a lot getting parts for my cars. Thus I have a fair idea what he carries. > > > __________________________________ > Do you Yahoo!? > Yahoo! Small Business - Try our new resources site! > > http://smallbusiness.yahoo.com/resources/ > > > > . ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist