Joe and Raylin, If there is a specific section of the stripe you would like to see? I have not seen the SC 360 stripe that Phoenix makes so I don't know what is wrong with it. What I can do if you tell me what you are looking for, is lay that section out and take a picture of it through the pre-mask. You should be able to see enough detail to tell. Since the list does not allow jpegs, I will send them to you off list. Other than that, I can tell you there are a number of guys on the list who have used my AMX T-stripes that can tell you about the quality and correctness of them. Mine might be a few dollars more but I spend a lot more time and money on the set up of them to make sure they are correct. Nick Alfano Date: Mon, 21 Feb 2005 16:31:14 -0500 From: neprocap@xxxxxxx Subject: Re: SC-360 Stripe Kit Questions To: mail@xxxxxxxxxxxx Message-ID: <ADVANCES62TOSzQhLE800003218@xxxxxxxxxxxxxxxxxxxxxxx> It looks like the one that Andre Jacob sells is made by Phoenix. Funny, I've never noticed that they were wrong until you pointed it out. I just haven't needed one. That is probably why they sell for only $169. I have never seen Nick's stripe kit so I don't know if it is correct. Nick should be easy to contact because he is a member of most of the AMC forums... Joe Roberts Medina, NY 69 S/C Rambler 71 SC/360 Hornet On February 21, 2005 raylin.nevland@xxxxxxxx wrote: > So far I have found only two places that recreate the SC-360 stripe: > Pheonix Reproductions and Nick Alfano. Looking at the picture Pheonix has > available I notice that it is not correct. It's close but any SC owner > can tell something wrong. It is easy to see the difference if you look at > the original SC360 sales ad. > > Can anyone verify that the Nick Alfano stripe kit is correct? Please send > a picture if possible. > > Thank you for your help with our restoration project. > > Raylin > > > >