It's worth a try, thank you.. THE NEEDS OF THE MANY OUTWEIGH THE NEEDS OF THE ONE.. ----- Original Message ----- From: Steven M.Dristy, Jr. <soundwve@xxxxxxx> To: <mail@xxxxxxxxxxxx> Sent: Wednesday, January 05, 2005 12:23 AM Subject: Re: Jeep Cherokee Tail Gate Question > I have had an '84 Cherokee Chief XJ and an '85 Wagoneer Limited XJ with the > same problem. > (My '86 Cherokee Pioneer had already had this fixed with fiberglass "Bondo" > by the time I got it.)What happens is the 3 holes the latch assembly screws > go thru get hogged out with the flexing and shaking of the door over the > road, and repeated closing of the door. I know the '84-'86 XJs had > fiberglass hatch doors, and the fiberglass seems to wear away here. A good > indicator of this problem is major difficulty in getting the hatch door to > latch closed. > > What I did with the '84 and '85 was to use sunken washers. They look like a > regular washer, except the middle (with the hole) is recessed, so the > screw/bolt head is flush with the surface. I was given 12 of these by a > carpender friend, so I assume you could find them at a hardware (NOT auto > parts) store. They seem to center the screws in the holes, and they work > amazingly well. Cheap fix, maybe $1.00-$1.50 for 12!! If you can't find 'em > there, I could see if I can find them here, and send 'em to you. > > ----- Original Message ----- > From: "Peter Klemmensen" <pklemmensen@xxxxxxxxx> > To: <mail@xxxxxxxxxxxx> > Sent: Tuesday, January 04, 2005 7:40 PM > Subject: Re: Jeep Cherokee Tail Gate Question > > > > This is for an 86 Cherokee chief, we have the back panel off for some work > > back there and the rattling is driving us nuts.. > > > > THE NEEDS OF THE MANY OUTWEIGH THE NEEDS OF THE ONE.. > > ----- Original Message ----- > > From: Jim Blair <carnuck@xxxxxxxxxxx> > > To: amc <mail@xxxxxxxxxxxx> > > Sent: Tuesday, January 04, 2005 6:22 PM > > Subject: Re: Jeep Cherokee Tail Gate Question > > > > > > > A: Fullsize or XJ? Fullsize has little rubber stppers that sit in holes > > that > > > the alignment pins go into. When the rubber wears out (or often, just > > falls > > > out because it is stuck to the pin when you open it) the metal on metal > > > squeak will drive you nuts! I used rubber vacuum caps on my '83 and they > > > needed replacing once in awhile (I opened the tailgate a lot) > > > > > > > > > From: "Peter Klemmensen" <pklemmensen@xxxxxxxxx> > > > To: "amc-list" <mail@xxxxxxxxxxxx> > > > Subject: Jeep Cherokee Tail Gate Question > > > Date: Tue, 4 Jan 2005 11:53:24 -0500 > > > > > > Our tail gate or hatch keep's rattling when we are driving down the > road, > > Is > > > there any way to stop this?????? It is driving us nuts to here it > rattail > > > all the time.. > > > > > > Pete.. > > > > > > > > > THE NEEDS OF THE MANY OUTWEIGH THE NEEDS OF THE ONE.. > > > > > > > > > > > > > > > > > > > >