Re: attn farna Re; Intake Manifold upgrade for the AMC 6
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: attn farna Re; Intake Manifold upgrade for the AMC 6



A: '87 to 08/90 Jeeps with 4.0L were Renix. HO is the later Chrysler setup. 
I found that the Renix setup manifold (and the 4.0L physically) bolted into 
my '84 J10 with very few mods to the XJ front pipe.


From: bill821@xxxxxxxxx (Bill Allen)
Date: Mon, 3 Jan 2005 12:48:59 -0500
To: mail@xxxxxxxxxxxx
Subject: attn  farna Re; Intake Manifold upgrade for the AMC 6
Message-ID: <20629-41D9858B-1472@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>

 I have a 82 SX/4.
 When you used the 87-90 tubular exhaust on your Eagle it was the HO
exhaust manifold. right? This I have.
 Did it match up with the existing down pipe that goes to the cat?
 If not. What pipe did you use?
 And did you use the HO gasket? Also have this.
 Did you have any problems with the manifold gasket?
 From the way I take it I can use a plate to cover the EGR opening. Have
this too.
 Can I use a a pipe plug in the hole in the underside of my intake
manifold where the pipe runs from the exhaust manifold? Any other
problems you know of that might arise? Thanks


    1@xxxxxxxxxxxxx    www.BillAllen.net 




Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated