Well it's been 4 years, but I'm finally putting a '72 360 in my 69 Rogue. Problem is, when I lower it into the engine bay, the motor mount studs are about 1/2" too far forward to drop into the slots/holes on the crossmember. The engine is right up against the firewall, so there's no room to slide it back. Anybody know if motor mounts or the rubber pads changed from '69 to '72, or have some solution to this problem? Thanks, Dave S. '66 American 440 w/290 and '69 Rogue with 360 (almost) ============================================================= Posted by wixList Archiver -- http://www.amxfiles.com/wixlist