Re: Mooing-Spewing- 65Rambler wont' start
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Mooing-Spewing- 65Rambler wont' start



Matt,

Thanks for the help. Yep, I got the service manual and have been using it.

The volt meter is my crutch. I can never seem to understand it. But if I can use a test light, i guess thats pretty 'dummy proof'.

I didn't have the key turned to "ON" when I did the "engine bay remote start". I hadn't thought that i would need to.. go figure. Will try again tomorrow.

For the negative battery/distributor body test.. do I just hold the lead to the body of the distributor and the other lead to the neg battery cable.. what should I get on the volt meter? And what setting should the volt meter be on? (as I said, im a dummy to volt meters)

To do that, disconnect the black wire from the Ignitor and connect a test wire to a known good ground. Turn the ignition on, hold the coil wire a short distance from a know good ground (a spark plug works well for this), and then momentarily touch your ground wire to the - coil terminal and pull it away. You should see a spark. If you do, chances are the Ignitor is dead -- try switching back to your points setup. If you don't see a spark, the coil is probably bad.


Im not sure about this? Im disconnecting the black wire from the coil (that goes to the distributor/Petronix)? The test wire is then connected to....where?








Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated