Re: [Amc-list] Doh question again - valve cover gasket?

[JOE FULTON <piper_pa20@xxxxxxxxxxx>]

Bruce,

The OHV 195.6 has a re-usable rubber valve cover
gasket. It may have been adhered to the valve cover in
your case, or it could actually have been missing. 
Felpro still makes the gasket.

Regards,
Joe Fulton

--- Bruce Griffis <bruce.griffis@xxxxxxxxx> wrote:

> This is probably just a d'oh question, but, ...
> 
> I popped off my valve cover and there was no gasket
> for it. After
> looking around and going "gee whiz!", I popped the
> valve cover back on
> and screwed down with the 2 screws with gaskets. I
> did not use a
> gasket around the valve cover, nor did I use any RTV
> sealer or
> whatever.
> 
> So - the dumb question is: on the cast iron 196 OHV
> engine, do you use
> a gasket for the valve cover? Do you use sealant?
> I'm thinking yes,
> but wanted to show my ignorance in it's full
> ignorant glory.
> 
> < ;-)     (that's supposed to be a dunce cap ascii
> smiley)
> _______________________________________________
> Amc-list mailing list
> Amc-list@xxxxxxxxxxxx
>
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list
> 

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://splatter.wps.com/cgi-bin/mailman/listinfo/amc-list