Re: [Amc-list] 287/327 trans. stuff

["Swygert, Francis G MSgt 436 CES/CECM" <Francis.Swygert3@xxxxxxxxxxxx>]

I don't think I've actually pulled a T-86 trans, just the T-96 and T-89.
Sounds like the T-86 is closer to the T-96 pattern, which I believe is
just a little wider than tall. T-86 may have a pattern of it's own
though. I found that the SR-4 even shares the top two bolt holes with a
T-96, so the top holes seem to be about the same on all of them -- you
can only go so far into the floor!

-----------------
Date: Monday, April 23, 2007 03:04 PM
From: andrew hay <adh@xxxxxxxxxxxxxxxxx>

" From: "Swygert, Francis G MSgt 436 CES/CECM"
<Francis.Swygert3@xxxxxxxxxxxx>
"
"
" The T-89 and T-86 should have the same bell housing bolt pattern IIRC,

afaik they don't.  the t89 is tall and narrow like the t10 [for those
who know it], but the t86 is almost square, same as the later t15.
this shares the same top two bolts as the t10 but the bottom two are
much higher up.

" but I'm not sure about the input shaft length. The 86 may use a
" shallower bell, though I seriously doubt it.

i think you're right, shared bell but with 2 [or 1 1/2] patterns.

_______________________________________________
Amc-list mailing list
Amc-list@xxxxxxxxxxxx
http://www.amc-list.com/mailman/listinfo/amc-list