Hello Daniel, I'm the one who put a H.E.I. distributor in my V8 Gremlin.It's not to bad if you have a good Machinist! You'll have to use your distributor drive gear and shaft measurments to build a new one.Get an aluminum 2" piece of stock, and start milling down to match your old shaft.Remember the firing order is the same as Chevorlet.Believe it or not the distributor,as large as it is will clear the power steering pump and A/C compressor.Any further questions ,please E-Mail me. Phil Sanchez ----- Original Message ----- From: "Daniel Modlin" <dmodlin@xxxx> To: <gremlintime@xxxxxxxxxxx> Sent: Sunday, November 19, 2000 7:03 PM Subject: [gremlintime] HEI > Who was it on this list that was going to do this swap? I'm curious what's > involved and how effective it is. > > > Community email addresses: > Post message: gremlintime@xxxxxxxxxxx > Subscribe: gremlintime-subscribe@xxxxxxxxxxx > Unsubscribe: gremlintime-unsubscribe@xxxxxxxxxxx > List owner: gremlintime-owner@xxxxxxxxxxx > > Shortcut URL to this page: > http://www.onelist.com/community/gremlintime > Gremlintime(Home of the AMC Gremlin on the WWW): > http://www.geocities.com/gremlintime > >