The folks below are building a Jeep, and are looking for some towing advise, including what might best fit their needs with cam/carb/intake setup. Chances are some of you would like to comment and feel free to, be sure to copy your reply to Randy directly also and thanks in advance to all who might reply. Eddie Stakes 713.464.8825 eddiestakes@xxxxxxxxxxxxxxxxxxxx www.planethoustonamx.com ----- Original Message ----- From: randallschroeder@xxxxxxxxxxxxxx Eddie; Can I get some advice from you? I have a 74 Cherokee with a 401 which is used for pulling my RV or boat. The RV can make it work. I decided to keep it (the Cherokee) and would like to up the performance for better pulling. Can you suggest a cam/intake/carb that would work for this situation? Will the stock cast heads work as well as the edelbrok aluminum that are out there for this pulling-type load? Since the interest in this engine seems to be going up, I'd like to spend some coin and do it right. Thanks for anything you can throw at me. Randy Schroeder PO Box 39 Markesan, WI 53946 ------------------------------------ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/BaadAssGremlins/join (Yahoo! ID required) <*> To change settings via email: BaadAssGremlins-digest@xxxxxxxxxxxxxxx BaadAssGremlins-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/