Re: Fw: [BaadAssGremlins] Fw: Car is done but slow off the line also engine noise start up

[Rick Griffin <amc_poppy@xxxxxxxxx>]

When you installed the engine was the engine fresh-or had it been run in on a dyno? If it was fresh how did you break in the cam. There have been a lot of problems the last few years with cams wiping a lobe or lobes when not run in properly[1800-2000 rpm ]for first 20 minutes or so.The noise and the lack of inital oiling does worry me some.

--- On Mon, 4/14/08, Eddie Stakes <eddiestakes@xxxxxxxxxxxxxxxxxxxx> wrote:

From: Eddie Stakes <eddiestakes@xxxxxxxxxxxxxxxxxxxx>
Subject: Re: Fw: [BaadAssGremlins] Fw: Car is done but slow off the line also engine noise start up
To: "arthur herrmann II" <sladeamx@xxxxxxxxx>
Cc: baadassgremlins@xxxxxxxxxxxxxxx
Date: Monday, April 14, 2008, 5:41 PM

Thansk to all of you who have replied so far.

 

----- Original Message -----

From: arthur herrmann II

To: Eddie Stakes

Sent: Monday, April 14, 2008 1:37 PM

Subject: Re: Fw: [BaadAssGremlins] Fw: Car is done but slow off the line also engine noise start up

How about the lifter clater at start up.  Is that caused by any of the oiling stuff or the oiling bypass part from bulltear? Or is it a defective cam or lifters?

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___