Joe.... I would lay them side by side and check the location and size of the weight...if they do not look the same then I would get the new one match balanced to the old one......that way you do not have to have the whole assbly rebalanced....JMO.... Jim jgray_55 wrote: > > Jim. Question...what if the two brands of flexplates were NOT exactly > the same as far as balance? that's why i asked about rebalancing my > assy? thanks,Joe--- In BaadAssGremlins@xxxxxxxxxxxxxxx > <mailto:BaadAssGremlins%40yahoogroups.com>, James > Shadwick <idahoamx@...> wrote: > > > > Joe... > > I have one on the 401 in the Gremlin.....I had my rotating assembly > > balanced with it....but the two should be > > the same....most of the time the flexplate balance is not changed > when > > the assembly is balanced so you can change > > it if needed in the future and not get the engine rebalanced.... > > Jim > > > > jgray_55 wrote: > > > > > > I had my 401 machined/balanced last year. Getting ready to > assemble > > > this winter...FINALLY! When i originally had it balanced all i > had for > > > a flexplate was one of the cheap/regular aftermarket flexplates. > NOW i > > > have a new sFI certified one. Can i just have my new flexplate > balance > > > to match the other one....or will i have to re balance the whole > > > rotating assembly? Thanks,joe > > > > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/BaadAssGremlins/join (Yahoo! ID required) <*> To change settings via email: mailto:BaadAssGremlins-digest@xxxxxxxxxxxxxxx mailto:BaadAssGremlins-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/