Has anyone ever done this? It looks like it can be done but with 1 hole 3/8's of a Inch away from a hole on the 727 flywheel. The hole also are just a tad onto the curve There would need to be spacers made to go in between flexplate and the flywheel because the th400 has raised bosses on it and the th400 doesnt. Unless I have it backwards and they are inset....... Then I dont know what to do. Got any ideas? Also.... Please tell me there is only one way to install the flywheel... I didnt have flywheel on my 401 when I got it but it was attached to a th400 in a cj8. Later on down the road I ended up going back and getting the same tranny that was on my 401 from the guy and got the flex plate with it. So no matter what flex plate I end up using I wouldnt know which way to bolt it on the motor to balance it correctly.... So Am I screwed? Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/BaadAssGremlins/join (Yahoo! ID required) <*> To change settings via email: mailto:BaadAssGremlins-digest@xxxxxxxxxxxxxxx mailto:BaadAssGremlins-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/