Re: [BaadAssGremlins] intake recomendations
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [BaadAssGremlins] intake recomendations



In a message dated 10/16/2006 5:25:04 P.M. Eastern Standard Time, timkott@xxxxxxxxx writes:
Im almost finished with my 401 build, have to decided on a intake and roller rockers. What
are your recomendations, I've told myself im in a limited budget, but have been looking at
mad dog as they have a roller rocker setup out of machined aluminum. Got to see it in
person and was very impressed. sells on ebay for 800$ Also was looking at a RPM Air Gap
intake manifold. Are there anyother recomendations? This will be primarily a strip car, but
with some streetablity to it.
You stated your on a budget. Some Harland Sharp 1.6  3/8 stud roller rockers would work just fine and either a Edelbrock Torker  or Air gap would be good but then again how built up is your engine?
Bart
__._,_.___


SPONSORED LINKS
Automotive advertising Automotive lifts Automotive dealer new car

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___


Home Back to the Home of the AMC Gremlin 


This site contains affiliate links for which we may be compensated