What I thought would be a 1/2 hour to 1 hour job took almost 3 to install the pass side rear door panel. I made these panels completely from scratch using an old original one from my yellow car for a template. The pass door panel just about popped in and was a perfect fit, the pass rear one was a fight. I am using original factory clips to hold the panels on not like some custom interior builders that use trim screws. I was slightly off on the mounting holes for 2 clips and couldn't get them to line up with the holes in the body no matter how hard I tried. with the other 5 clips the panel fit nice but I had to do somthing about the 2 missing ones so I added a piece of 2 sided exterior carpet tape in place of the clips. It was that or nothing. I also had to drill one new hole for the factory chrome trim screw that holds the door panel at the very back to the hatch panel because of the extra paddling on my custom panels. What a pain but the results once you looked at it is beautiful. Today I will attempt to install the drivers side rear panel. I hope this one will go in without a problem. Yea right fat chance. Everything I have done on this car in the last 18 months since I bought it has been a fight. "Doc" Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/BaadAssGremlins/ <*> To unsubscribe from this group, send an email to: BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/